![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745509.webp)
3 - 4
Assembly (cont’d)
6
Apply grease to a new 'O'-ring
I
and install it on the
shaft
D
.
Clean the metallic face of the seal, coat the metallic
face
with engine oil and install the hub
C
onto the shaft
D
.
Fit new wire clip
E
or roll pin
F
.
Wrap sealing tape around the plug
A
with one thread
remaining uncovered. Insert this plug but leave the
other one out until after testing.
7
Using extreme care to prevent water entering the
assembly, lower it into a tank of water. Connect
compressed air at
M
and apply pressure of 1.9 bar (28
lbf/in
2
). Check for air bubbles.
8
Remove the assembly from the tank. Dry with
compressed air. Add engine oil via plug
A
aperture.
Install plug using an appropriate pipe sealant.
9
Carry out steps 1 to 4 of
Idler Wheel and Recoil Unit,
Replacement.
Section J
Track and Running Gear
9803/6410
Section J
3 - 4
Issue 1
Idler Wheel
F
G
D
I
C
E
A
M
A
Summary of Contents for JS130
