Basic Steps for Installing
the Ascent
®
Dumbwaiter
©2007 Harmar
1. Remove Shroud.
2. Mount lower section of Track and Unit to hoistway wall and
Brackets.
3. Remove Shipping Bracket from Top of Car.
4. Install other track pieces and brackets.
5. Set Header on top end of Track and attach Steel Cable.
6. Make wiring connections at Header.
7. Run lift in up direction (using temporary pendant control) to
wind the steel cable onto the drum.
8. Mount Cams on Track.
9. Install Interlocks.
10. Test in Automatic Operation
11. Attach Header Cover and Shroud.
Note:
Harmar designs the
dumbwaiter
to meet the requirements of
ASME A17.1.
Installe
r
to check with
local authorities to assure
local
and state
code compliance, installation
requirements, and
to determine if permits are required.
Save these instructions.
630-00092- Rev.
B
Summary of Contents for Ascent DW100
