D-Link DES-3326SRM, Command Line Interface Reference Manual

Page: 330 / 354

DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual
330 OSPF Configuration Commands
config ospf all
Purpose Used to configure all of the OSPF interfaces
on the switch at one time.
Syntax config ospf all {area <area_id>/priority
<value>/hello_interval
<sec>/dead_interval <sec>/authentication
[none/simple <password>/md5
<key_id>]/metric <value>/state
[enabled/disabled]}
Description This command is used to configure all of the
OSPF interfaces on the switch, using a
single group of parameters, at one time.
Parameters
priority <value>
−
The priority used in the
election of the Designated Router (DR). A
number between 0 and 255.
metric <value>
−
The interface metric (1 to
65535). Entering a 0 will allow automatic
calculation of the metric.
hello_interval <sec>
−
Allows the
specification of the interval between the
transmission of OSPF Hello packets, in
seconds. Between 5 and 65535 seconds can
be specified. The Hello Interval, Dead
Interval,
Authorization Type, and
Authorization Key should be the same for all
routers on the same network.
dead_interval <sec>
−
Allows the
specification of the length of time between
the receipt of Hello packets from a neighbor
router before the selected area declares that
router down. An interval between 5 and