D-Link DES-3326SRM, Command Line Interface Reference Manual

Page: 221 / 354

DES-3326SR Layer 3 Fast Ethernet Switch CLI Reference Manual
Route Redistribution Commands 221
create route redistribute dst ospf
Purpose Used to add route redistribution settings for
the exchange of RIP routes to OSPF routes
on the switch.
Syntax create route redistribute dst ospf src
[static/rip/local] {mettype [1/2]/metric
<value>}
Description This command will redistribute routing
information between the OSPF and RIP
routing protocols to all routers on the
network that are running OSPF or RIP.
Routing information entered into the Static
Routing Table on the local DES-3326SR
switch is also redistributed.
Parameters
src [static/rip/local]
−
Allows for the
selection of the protocol for the source
device.
dst
−
Allows for the selection of the protocol
for the destination device.
mettype [1/2]
−
Allows for the selection of
one of two methods of calculating the metric
value. Type-1 calculates (for RIP to OSPF)
by adding the destination
’ s interface cost to
the metric entered in the Metric field. Type-
2 uses the metric entered in the Metric field
without change. this field applies only when
the destination field is OSPF.
<value>
−
Allows the entry of an OSPF
interface cost. This is analogous to a Hop
Count in the RIP routing protocol.