Yamaha WR450F(S), Руководство по эксплуатации для владельца

Страница: 272 / 754

3 - 46
INSP
ADJ
STEERING HEAD INSPECTION AND ADJUSTMENT
●
Tighten the ring nut 3 using ring nut
wrench
4
.
NOTE:
Set the torque wrench to the ring nut wrench
so that they form a right angle.
Ring nut wrench:
YU-33975/90890-01403
T
R
.
.
Ring nut (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
●
Loosen the ring nut one turn.
●
Retighten the ring nut using the ring nut
wrench.
WARNING
Avoid over-tightening.
T
R
.
.
Ring nut (final tightening):
7 Nm (0.7 m • kg, 5.1 ft • lb)
●
Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
●
Install the plain washer 5 , handle crown
6 , plain washer 7 , steering shaft nut 8 ,
steering shaft cap 9 , handlebar 0 , han-
dlebar holder A and headlight B .
NOTE:
●
The handlebar holder should be installed
with the punched mark
a
forward.
●
Insert the end of the fuel breather hose C
into the hole in the steering shaft cap.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
T
R
.
.
Steering shaft nut:
145 Nm (14.5 m • kg, 105 ft • lb)
Handlebar holder:
28 Nm (2.8 m • kg, 20 ft • lb)
Pinch bolt (handle crown):
23 Nm (2.3 m • kg, 17 ft • lb)
Headlight (left and right):
10 Nm (1.0 m • kg, 7.2 ft • lb)
Headlight (lower):
7 Nm (0.7 m • kg, 5.1 ft • lb)