6. ROM
Rev.3.00 Jul. 19, 2007 page 154 of 532
REJ09B0397-0300
Table 6.11 Writer Mode Commands
Number of
1st Cycle
2nd Cycle
Command Name
Cycles
Mode
Address Data Mode Address Data
Memory read mode
1 + n
write X
H'00 read RA
Dout
Auto-program
mode 129
write X
H'40 write WA
Din
Auto-erase
mode
2
write X
H'20 write X
H'20
Status read mode
3
write X
H'71 write X
H'71
Legend:
RA: Read
address
WA: Programming
address
Dout: Read data
Din: Programming
data
Notes: 1. In auto-program mode, 129 cycles are required for command writing by means of a
simultaneous 128-byte write.
2. In memory read mode, the number of cycles depends on the number of address write
cycles (n).
6.8.4
Memory Read Mode
1. After the end of an auto-program, auto-erase, or status read operation, the command wait state
is entered. To read memory contents, a transition must be made to memory read mode by
means of a command write before the read is executed.
2. Command writes can be performed in memory read mode, just as in the command wait state.
3. Once memory read mode has been entered, consecutive reads can be performed.
4. After power-on, memory read mode is entered.
5. Do not make a setting outside the valid address range.
Summary of Contents for F-ZTAT H8 Series
