Mitsubishi Electric C80 Series, Manual

Page: 498 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
481 IB-1501279-H
Set the compensation amount for the range of each position during rapid traverse.
(+: B1, =: B2, -: B3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
Set the compensation amount for the range of each position during rapid traverse.
(+: B1, =: B2, -: B3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999(Interpolation unit)
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
Set the speed range during cutting feed.
(The speed less than 1 is the low speed, and the speed exceeding 2 is the high speed.)
Note that the speed range is identified in the order of low, high and medium speed. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 480000 (mm/min)
Set the range of the speed during cutting feed.
(The speed less than 1 is the low speed, and the speed exceeding 2 is the high speed.)
Note that the speed range is identified in the order of low, high and medium speed. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 480000 (mm/min)
Set the range of the distance during cutting feed.
(The distance less than 1 is the small distance, and the distance exceeding 2 is the large distance.)
Note that the distance range is identified in the order of small, large and medium. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 999999.999999 (mm)
#2123 G0vback= Variable G0 backlash =
#2124 G0vback- Variable G0 backlash -
#2125 Variable G1 ba
#2126 G1vback= Variable G1 backlash =
#2127 G1vback- Variable G1 backlash -
#2128 G1vback feed1 G1 variable backlash compensation amount change-
over speed 1
#2129 G1vback feed2 G1 variable backlash compensation amount change-
over speed 2
#2130 G1vback dist1 G1 variable backlash compensation amount change-
over distance 1