Mitsubishi Electric C80 Series, Manual

Page: 235 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
218 IB-1501279-H
15.2 Fixed Cycle Parameters
Set the return amount for G73 (step cycle).
---Setting range---
0 to 99999.999 (mm)
Set the return amount for G83 (deep hole drilling cycle).
---Setting range---
0 to 99999.999 (mm)
Set the chamfering amount for G76, G78 (thread cutting cycle).
---Setting range---
0 to 127 (0.1 lead)
Set the chamfering angle for G76, G78 (thread cutting cycle).
---Setting range---
0 to 89 (°)
Set the minimum value of the last cutting amount by the rough cutting cycle (G71, G72).
The cutting amount of the last cutting will be the remainder. When the remainder is smaller than this param-
eter setting, the last cycle will not be executed.
---Setting range---
0 to 999.999 (mm)
Set the change amount of the rough cutting cycle.
The rough cutting cycle (G71, G72) cutting amount repeats x+dx, x, x-dx using the value (x) commanded with
D as a reference. Set the change amount dx.
---Setting range---
0 to 999.999 (mm)
Set the retract amount m in a G84/G74/G88 pecking tapping cycle.
(Note) In the case of a normal tapping cycle, set to "0".
---Setting range---
0 to 999.999 (mm)
Set the amount of cut-in by the rough cutting cycle (G71, G72)
---Setting range---
0 to 99999.999 (mm)
Set the amount of pull-up when returning to the cutting start point for the rough cutting cycle (G71. G72).
---Setting range---
0 to 99999.999 (mm)
Set the X-axis cutting margin of the forming rough cutting cycle (G73).
---Setting range---
-99999.999 to 99999.999 (mm)
#8012 G73n (for M system only)
#8013 G83 n
#8014 CDZ-VALE (for L system only)
#8015 CDZ-ANGLE (for L system only)
#8016 G71 MINIMUM (for L system only)
#8017 G71 DELTA-D (for L system only)
#8018 G84/G74 n
#8051 G71 THICK
#8052 G71 PULL UP
#8053 G73 U