Mitsubishi Electric C80 Series, Manual

Page: 373 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
356 IB-1501279-H
Set the length within the orthogonal coordinate of the inclined axis, a side of the triangle formed with the in-
clination angle.
---Setting range---
-9999.999 to 9999.999
Set the actual length of the base axis corresponding to the inclined axis, a side of the triangle formed with
the inclination angle.
---Setting range---
-9999.999 to 9999.999
Set the actual length of the inclined axis, a side of the triangle formed with the inclination angle.
---Setting range---
-9999.999 to 9999.999
Set the upper limit value of the feedrate when the external deceleration signals are enabled.
---Setting range---
1 to 999999 (mm/min)
Specify the number of the rotational tool axis (servo axis) used for polygon machining (G51.2).
Set "0" when not using polygon machining (spindle-servo axis), or when using spindle-spindle polygon ma-
chining.
A value exceeding the base specification parameter "#1002 axisno" cannot be specified.
This parameter is valid when the G code system is 6 or 7 ("7" or "8" is set in base specification parameter
"#1037 cmdtyp").
---Setting range---
0 to controlled axis number
Select whether to perform a deceleration check when the travel direction is changed from G1 to G0.
0: Not perform
1: Perform
Select whether to perform a deceleration check when the travel direction is changed from G1 to G1.
0: Not perform
1: Perform
Select whether the check is carried out at the specified position in manual second reference position return
mode upon completion of spindle orientation or at second reference position return interlock signal.
0: Upon completion of spindle orientation
1: At second reference position return interlock signal
Set the maximum value up to which the F 1-digit feedrate can be changed.
---Setting range---
0 to 1000000 (mm/min)
Set the constant that determines the speed change rate per manual handle graduation in F 1-digit feedrate
change mode.
---Setting range---
0 to 32767
(PR) #1213 proaxy Side 1 of inclination angle (for L system only)
(PR) #1214 macaxy Side 2 of inclination angle (for L system only)
(PR) #1215 macaxx Side 3 of inclination angle (for L system only)
#1216 extdcc External deceleration level
#1501 polyax Rotational tool axis number (for L system only)
#1502 G0Ipfg G1 -> G0 deceleration check
#1503 G1Ipfg G1 -> G1 deceleration check
#1505 ckref2 Second reference position return check
#1506 F1_FM Upper limit of F1-digit feedrate
#1507 F1_K F 1-digit feedrate change constant