Mitsubishi Electric C80 Series, Manual

Page: 236 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
219 IB-1501279-H
Set the Z-axis cutting margin of the forming rough cutting cycle (G73).
---Setting range---
-99999.999 to 99999.999 (mm)
Set how many times cutting will be performed in the forming rough cutting cycle (G73).
---Setting range---
0 to 99999 (times)
Set the amount of retract in the cut-off cycle (G74, G75).
---Setting range---
0 to 999.999 (mm)
Set the amount of final cut-in by the compound type thread cutting (G76).
---Setting range---
0 to 999.999 (mm)
Set how many times the amount of final cut-in cycle (G76 finish margin) will be divided in the compound type
thread cutting (G76).
---Setting range---
0 to 99 (times)
Set the angle (thread angle) of the tool nose in the compound type thread cutting (G76).
---Setting range---
0 to 99 (°)
Set the M command code for changing to the small diameter deep hole drilling cycle mode.
---Setting range---
1 to 99999999
Set the clearance amount for the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 999.999 (mm)
Set the feedrate from the R point to the cutting start position in the small diameter deep hole drilling cycle
(G83).
---Setting range---
0 to 99999 (mm/min)
Set the speed for returning from the hole bottom during the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 99999 (mm/min)
#8054 G73 W
#8055 G73 R
#8056 G74 RETRACT
#8057 G76 LAST-D
#8058 G76 TIMES
#8059 G76 ANGLE
#8083 G83S modeM (for M system only)
#8084 G83S Clearance (for M system only)
#8085 G83S Forward F (for M system only)
#8086 G83S Back F (for M system only)