Mitsubishi Electric C80 Series, Manual

Page: 464 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
447 IB-1501279-H
Select whether to enable multiple spindle synchronization.
0: Disable
1: Enable
Select the tool command method.
0: Tool life management II format
1: Tool function
Select whether to enable the G00 rapid traverse overlap function.
0: Disable
1: Enable
Select whether to enable the G28 rapid traverse overlap function.
0: Disable
1: Enable
Select whether to stop all the part systems or only the part system whereH/W-OT, soft limit or interference
check alarm has occurred.
(Note) If H/W-OT, soft limit or interference check alarm has occurred on an axis related to superimposition,
synchronization, arbitrary axis superimposition, or synchronization during axis traveling, the part system to
which the superimposition (synchronous) and basic axes belong is treated as the one where the alarm has
occurred.
0: Stop each part system
1: Stop all the part systems
Select whether to display or hide additional information on the tool management screen.
0: Display
1: Not display
Select the operation to be performed when command T has no tool length offset No.
0: Tool length offset No. is deemed as 0.
1: Last commanded tool length offset No. is applied.
(Tool length offset No. is unchanged.)
0: Disable a spindle rotation command given in another part system
1: Enable a spindle rotation command given in another part system
0: Disable cancel of the error
1: Enable cancel of the error
0: Rapid traverse rate (#2001 rapid) serves as the maximum speed in jog, handle, incremental or manual
reference position return (high-speed) mode. However you can use a PLC device to switch the maxi-
mum speed to the manual feed clamp speed (#2614 m_clamp).
1: Manual feed clamp speed (#2614 m_clamp) serves as the maximum speed in jog, handle, incremental,
or manual reference position return (high-speed) mode.
(PR) #1440 multi_sp_syn Multiple spindle synchronization valid
(PR) #1441 Tcode_Method_Chg T command method selection
#1442 G0ol Enable G00 rapid traverse overlap
#1443 G28ol Enable G28 rapid traverse overlap
#1444 otsys Stop all part systems at OT
(PR) #1445 Tol-Custom-nondisp Non-display of additional info on tool management
screen
#1446 Tlno.hold Tool length offset No. retention
#1447 G96_tmp_cancel Temporary cancel of constant surface speed control
#1448 Sclamp_err_cancel Cancel of the error for absence of spindle speed clamp
#1449 m_clamp_on Manual feed rate clamp ON