Mitsubishi Electric C80 Series, Manual

Page: 9 / 748

(1) Product and manual
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by the machine tool
builder takes precedence over this manual.
Items not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all the applicable functions are included. Some of them, however, may not
be available for your NC system. Refer to the specifications issued by the machine tool builder before use.
Refer to the Instruction Manual issued by each machine tool builder for details on each machine tool.
Some screens and functions may differ depending on the NC system (or its version), and some functions may not be pos-
sible. Please confirm the specifications before use.
Do not connect NC system to the Internet-connected network.
To maintain the safety of the NC system against unauthorized access from external devices via the network, take appro-
priate measures.
(2) Adjustments
Do not adjust or change the parameter settings greatly as operation could become unstable.
In the explanation on bits, set all bits not used, including blank bits, to "0".
(3) Troubleshooting
If the battery low warning is issued in the controller side, save the machining programs, tool data and parameters in an
input/output device, and then replace the battery. When the battery alarm is issued, the machining programs, tool data and
parameters may have been destroyed. Replace the battery and then reload the data.
If the battery low warning is issued in the drive unit side, immediately replace the battery. Replace the batteries while ap-
plying the drive unit's control power.
(4) Maintenance, inspection and part replacement
Do not short-circuit, charge, heat, incinerate or disassemble the battery.
Dispose of the spent battery according to local laws.
CAUTION