Mitsubishi Electric C80 Series, Manual

Page: 376 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
359 IB-1501279-H
Specify which spindle to be selected when G44.1 is commanded.
<Spindle No. type>
Specify by the spindle No. 1 to 8.
The 2nd spindle is selected if you specify a nonexistent spindle No.
<Spindle name type>
Specify by the spindle name 1 to 9.
The 2nd spindle is selected if you specify a nonexistent spindle name.
(Note) If names (1 to 9) have been set in the spindle name parameter "#3077 Sname" for all spindles, <Spin-
dle name type> is used.
---Setting range---
0 to 9
Set the minimum turning movement amount of the normal line control axis at the block joint during normal
line control.
---Setting range---
0.000 to 99999.999 (mm) (Input setting increment applies)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
(PR) #1534 SnG44.1 Spindle No. for G44.1 command
#1535 C_leng Minimum turning movement amount
#1537 crsax[1] Mixed control (cross axis control) axis
#1538 crsax[2]
#1539 crsax[3]
#1540 crsax[4]