Mitsubishi Electric C80 Series, Manual

Page: 601 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
584 IB-1501279-H
[M8]
Specify the number of motor-side gear teeth for "Gear selection command (Control input 4/bit6, 5) = 00".
When 0 is set, extended gear ratio is disabled.
When not using extended gear ratio, set 0.
---Setting range---
0 to 2147483647
[M8]
Specify the number of motor-side gear teeth for "Gear selection command (Control input 4/bit6, 5) = 01".
When 0 is set, extended gear ratio is disabled.
When not using extended gear ratio, set 0.
---Setting range---
0 to 2147483647
[M8]
Specify the number of motor-side gear teeth for "Gear selection command (Control input 4/bit6, 5) = 10".
When 0 is set, extended gear ratio is disabled.
When not using extended gear ratio, set 0.
---Setting range---
0 to 2147483647
[M8]
Specify the number of motor-side gear teeth for "Gear selection command (Control input 4/bit6, 5) = 11".
When 0 is set, extended gear ratio is disabled.
When not using extended gear ratio, set 0.
---Setting range---
0 to 2147483647
[M8]
Specify the motor temperature at which spindle protection starts.
When the spindle motor temperature reaches the set temperature or higher, the acceleration/deceleration
time constant is switched from that of S command to that for spindle protection.
Set a temperature that is the same as or higher than the spindle protection cancel temperature.
When 0 is set, the spindle acceleration/deceleration time constant is not switched according to the tempera-
ture.
---Setting range---
0 to 200 (°C)
[M8]
Specify the motor temperature at which spindle protection is cancelled.
When the spindle motor temperature drops below the set temperature, the acceleration/deceleration time
constant is switched from that for spindle protection to that of S command.
Set a temperature that is the same as or lower than the spindle protection start temperature.
When the set temperature is 0 or higher than the spindle protection start temperature, the cancel temperature
is set 10 degrees lower than the start temperature.
---Setting range---
0 to 200 (°C)
(PR) #43080 GRB1ex Motor-side extended gear ratio 1
(PR) #43081 GRB2ex Motor-side extended gear ratio 2
(PR) #43082 GRB3ex Motor-side extended gear ratio 3
(PR) #43083 GRB4ex Motor-side extended gear ratio 4
#43084 protect_sp_st_tmp Spindle protection start temperature
#43085 protect_sp_rls_tmp Spindle protection cancel temperature