Mitsubishi Electric C80 Series, Manual

Page: 691 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
674 IB-1501279-H
16.25 PLC Axis Indexing Parameters
Set the axis No. to be controlled as auxiliary axis using auxiliary axis interface.
When "0" is set, the axis will not operate as auxiliary axis.
---Setting range---
[M8]
0 to 8: (M800W/M800S Series)
0 to 4: (M80/M80W Series)
0 to 1: (E80)
[C80]
0 to 8
Set the number of stations.
For linear axis, this value is expressed by: number of divisions = number of stations -1.
Setting "0" or "1" sets the number of stations to 2.
---Setting range---
0 to 360
The bits that are not explained here must be set to "0".
Bit3:
0: Automatic reach signal isn't interlocked with the start signal.
1: Automatic reach signal is interlocked with the start signal.
Bit4:
0: Automatic reach signal is turned ON again.
1: Automatic reach signal isn't turned ON again.
Bit5:
0: Station No. Output within fixed position.
1: Station No. Constantly output.
bit9:
0: Rotation direction determined by operation control signal (DIR)
1: Rotation direction in the shortcut direction
bitE:
0: Rotation direction in operation control signal (DIR) or in the shortcut direction
1: Rotation direction in the arbitrary position command sign direction
bitF:
0: Stopper direction is in the positioning direction.
1: Stopper direction is in the sign direction of the stopper amount.
The bits that are not explained here must be set to "0".
bit4:
0: Uniform assignment
1: Arbitrary coordinate assignment
Set the movement stroke length for linear axes.
(Note 1) Setting "0.000" causes an MCP alarm at the power ON.
(Note 2) This parameter is meaningless at the non-uniform index or random position command.
---Setting range---
0.000 to 99999.999 (mm)
(PR) #12800 chgauxno Auxiliary axis number
(PR) #12801 aux_station Number of indexing stations
(PR) #12802 aux_Cont1 Control parameter 1
(PR) #12803 aux_Cont2 Control parameter 2
(PR) #12804 aux_tleng Linear axis stroke length