Mitsubishi Electric C80 Series, Manual

Page: 241 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
224 IB-1501279-H
Select whether to keep the tool length offset by high speed manual reference position return during tool
length offset.
0: Will not be kept (Cancel)
1: Kept
Select whether to enable the drilling cycle at high-speed retract in fixed cycle for drilling.
0: Disable
1: Enable
Select the operation type of the mirror image by parameter setting and the mirror image by external input.
0: The current mirror image is canceled, and new mirror image will start with the machine position at reset
as the mirror center.
1: The mirror center is kept to continue the mirror image.
Select how to operate when there is no S command in synchronous tapping block.
0: Use the spindle function modal value as S-command value.
1: Output a program error (P181).
[M8]
Disable operation tones when operating the keyboard/touch panel.
0: Enable the operation tones
1: Disable the operation tones
[C80]
Not used.
[M8]
Select the initial value of the coordinate system for a manual feed while a machining surface is selected in
the R-Navi function.
0: Feature coordinate system
1: Machine coordinate system
[C80]
Not used.
Select the subprogram No. to be called preferentially in subprogram control.
0: Commanded program No.
1: Four-digit program No. beginning with O No.
2: Eight-digit program No. beginning with O No.
(Note) The program to be called in user macro, figure rotation, macro interruption and compound type fixed
cycle also follows this setting.
Select the dwell operation to be carried out when G04 command is given.
0: Apply per-second dwell, irrespective of the synchronous feed mode (G95) or asynchronous feed mode
(G94)
1: Apply per-revolution dwell when synchronous feed mode (G95) is ON, but per-second dwell when asyn-
chronous feed mode (G94) is ON
---Setting range---
0/1
#8122 Keep G43 MDL M-REF
#8123 H-spd retract ON
#8124 Mirr img at reset
#8125 Check Scode in G84
#8126 Disable op tone
#8127 R-Navi manu F coor
#8129 Subpro No. select
#8130 Per-revol. dwell