Mitsubishi Electric C80 Series, Manual

Page: 242 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
225 IB-1501279-H
Switch to high-speed high-accuracy 3
Select whether to treat high-speed high-accuracy control II command as high-speed high-accuracy control
III command.
0 : Treat G05P10000 as high-speed high-accuracy control II command (G05P10000).
1 : Treat G05P10000 as high-speed high-accuracy control III command (G05P20000).
Select whether to execute a single block stop at the completion of rotation of each axis when G53.6 is given
with the number of simultaneous contour control axes limited to 4.
0 : Not execute a single block stop
1 : Execute a single block stop
[M8]
Specify the interactive macro to call from the cycle of interactive cycle insertion.
0: Call standard interactive macro
1: Call interactive macro in the machining program area
When a program, whose name is same as standard interactive macro, exists in the machining program area,
the program in the machining program area is called preferentially if "1" is set to this parameter.
When a program, whose name is same as standard interactive macro, does not exist in the machining pro-
gram area, standard interactive macro is called even if "1" is set to this parameter.
[C80]
Not used.
[M8]
E-mail sending by the email notification to operator can be disabled.
0: Enable
1: Disable
[C80]
Not used.
Single block stop is disabled during direct command mode.
0: Not disable single block stop
1: Disable single block stop
[M8]
Select whether to enable the turning-tool shape compensation in compound type fixed cycle for turning ma-
chining I.
0: Disable
1: Enable
[M8]
Select whether to display the pre-compensation finish shape of the turning-tool shape compensation for com-
pound type fixed cycle for turning machining I in 2D graphic check.
0: Display
1: Not display
#8131 High speed/accu 3
#8132 G53.6 block stop
#8133 Intrctv macro call
#8134 Email send disable
#8135 G5P4 single block
#8137 T. tool shape comp
#8138 Pre-compens. shape