Mitsubishi Electric C80 Series, Manual

Page: 380 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
363 IB-1501279-H
Select the axis to be moved later after tool return.
This is referred to with the movement path (return start point -> transit point #2).
Up to eight axes can be specified by expressing one axis with one bit.
bit0 : Transit point #2 1st axis
bit1 : Transit point #2 2nd axis
bit2 : Transit point #2 3rd axis
bit3 : Transit point #2 4th axis
bit4 : Transit point #2 5th axis
bit5 : Transit point #2 6th axis
bit6 : Transit point #2 7th axis
bit7 : Transit point #2 8th axis
---Setting range---
00000000 to 11111111 (Binary)
Specify the spindle No. or spindle name of rotary tool in "MITSUBISHI CNC Special Format(G81.4)" of hob-
bing command.
(Note) There are 2 spindle designation methods: spindle No. method and spindle name method.
When the name (1 to 9) is set to the spindle name parameter(#3077 Sname) for all the spindles, the com-
mands are issued with for each spindle name, other than that, the commands are issued with the spindle
number.
---Setting range---
0 to 9
Specify the NC axis No. of workpiece axis (in a part system) in "MITSUBISHI CNC Special Format (G81.4)"
of hobbing command.
This parameter is valid when "#1292 ext28/bit4 (Hobbing workpiece axis selection switch)" is "0".
---Setting range---
1 to the number of NC axes (in a part system)
[M8]
Specify the tolerable range for an error of the end point of travel command which is deviated from the tool
path direction during the G68.1 ,E1 command.
---Setting range---
0.000 to 100.000 (mm)
[C80]
Not used.
Set the part system axis name ("#1013 axname") for the two axes that intersect with the rotary axis direction.
When one of the two axes is blank, a constant speed will be applied without using constant surface speed
control.
---Setting range---
Axis addresses such as X, Y, Z, U, V, W, A, B, and C
Set the part system axis name ("#1013 axname") for the two axes that intersect with the rotary axis direction.
When one of the two axes is blank, a constant speed will be applied without using constant surface speed
control.
---Setting range---
Axis addresses such as X, Y, Z, U, V, W, A, B, and C
#1574 Ret2 Return type 2
#1595 hobm Hobbing rotary tool axis No.
#1596 hobs Hobbing workpiece axis No.
#1599 3DEndPointErr End point error in 3D coordinate conversion
#12001 ManualB RectanA xH Manual feed rate B constant surface control intersect-
ing part system axis name (horizontal)
#12002 ManualB RectanA xV Manual feed rate B constant surface control intersect-
ing part system axis name (vertical)