Mitsubishi Electric C80 Series, Manual

Page: 420 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
403 IB-1501279-H
bit0: Ignoring timing sync in multi-system simultaneous thread cut cycle I (G76.1)
Select whether to execute timing synchronization during multi-part system simultaneous thread cut cycle I
(G76.1).
0: Execute timing synchronization at the start and end of thread cutting.
1: Ignore the timing synchronization given during the cycle.
bit1: G92.1 single command error check ON
Select whether to enable the error check when G92.1(G50.3) is given alone in a block.
0: Disable the error check
1: Enable the error check
bit2:
[M8]
Select whether to output an operation error upon detection of spindle speed fluctuation (G162).
0: Output an operation error
1: Not output an operation error
[C80]
Not used.
bit6: G113 command type when multiple spindle synchronization set valid
Specify the G113 command type of when multiple spindle synchronization set is valid.
0: Cancels all the spindle synchronization by issuing G113H0 or G113D0.
1: Cancels all the spindle synchronization by issuing G113.
Not used. Set to "0".
#1242 set14
#1243 set15