Mitsubishi Electric C80 Series, Manual

Page: 368 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
351 IB-1501279-H
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F4 is issued (mm/min)
When "#1246 set08/bit6" is set to "1" and F 1-digit feed is commanded, the feedrate can be increased/de-
creased by operating the manual handle.
---Setting range---
0 to 1000000 (mm/min)
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F5 is issued (mm/min)
When "#1246 set08/bit6" is set to "1" and F 1-digit feed is commanded, the feedrate can be increased/de-
creased by operating the manual handle.
---Setting range---
0 to 1000000 (mm/min)
Select whether to enable or disable inclined axis control.
0: Disable inclined axis control
1: Enable inclined axis control
Set the inclination angle ( θ ).
(Note) When set to "0", the angle determined by three-side setting will be applied.
---Setting range---
-80.000 to 80.000 (°)
Select whether to perform compensation for the base axis corresponding to the inclined axis at reference
position return.
0: Perform compensation
1: Not perform compensation
The setting is selected with the parameter "#1306 InpsTyp".
0: Deceleration check method 1
Select the deceleration check method for G0.
0: Command deceleration check
1: In-position check
2: Smoothing check
1: Validate in-position check
0: G0, G1+G9 Command deceleration check
1: G0, G1+G9 In-position check
2: G0, G1+G9 Smoothing check
Select the time constant for manual handle feed.
0: Use time constant for G01
1: Time constant 0 (step)
#1188 spd_F4 F1 digit feedrate F4
#1189 spd_F5 F1 digit feedrate F5
(PR) #1190 s_xcnt Validate inclined axis control (for L system only)
(PR) #1191 s_angl Inclination angle (for L system only)
(PR) #1192 s_zrmv Compensation at reference position return (for L sys-
tem only)
#1193 inpos Deceleration check method 1
#1194 H_acdc Time constant 0 for handle feed