Mitsubishi Electric C80 Series, Manual

Page: 256 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
239 IB-1501279-H
[M8]
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code "!".
When output with EIA code, data can be output using the alternate code in which the special ISO code, not
included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
[M8]
Set the device name corresponding to the device No.
Set a simple name for quick identification.
---Setting range---
Use alphabet characters, numerals and symbols to set a name within 3 characters.
[M8]
Select the serial communication speed.
0: 19200 (bps)
1: 9600
2: 4800
3: 2400
4: 1200
5: 600
6: 300
7: 110
[M8]
Select the stop bit length used in the start-stop system.
Refer to "#9304 DEV2 PARITY CHECK". At the output of data, the number of characters is always adjusted
to for the parity check.
1: 1 (bit)
2: 1.5
3: 2
[M8]
Select whether to add a parity check bit to the data.
Set this parameter in accordance with the I/O device specifications.
0: Not add a parity bit in I/O mode
1: Add a parity bit in I/O mode
[M8]
Select whether even or odd parity will be used when parity is used. This parameter is ignored when no parity
is added.
0: Odd parity
1: Even parity
#9228 DEV1 EIA CODE !
#9301 DEV2 DEVICE NAME
#9302 DEV2 BAUD RATE
#9303 DEV2 STOP BIT
#9304 DEV2 PARITY CHECK
#9305 DEV2 EVEN PARITY
Start bit Data bit Parity bit Stop bit
1character
ON
OFF
b1 b2 b3 b4 b5 b6 bn