Mitsubishi Electric C80 Series, Manual

Page: 624 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
607 IB-1501279-H
Not used. Set to "0".
Set the current feed forward rate in OMR-FF control.
The standard setting is "10000".
Setting value of 0 is equal to "10000(100%)" setting.
Set to "0" when not using OMR-FF control.
---Setting range---
0 to 32767 (0.01%)
Set the current command value for when the open loop control is enabled.
When "0" is set, the state will be the same as when "50" is set.
When not using, set to "0".
The open loop control is enabled when "SP018/bit1" is set to "1".
---Setting range---
0 to 999 (Short-time rated %)
Set the time required to cut off the gate when turning OFF/ON the coil switch contactor.
The value should be longer than the coil switch contactor's OFF/ON time.
The standard setting is "150".
---Setting range---
0 to 3500 (ms)
Set the time required to limit the current immediately after the coil switch contactor ON/OFF is completed and
the gate is turned ON.
The standard setting is "250".
---Setting range---
0 to 3500 (ms)
Set the time required to limit the current immediately after the coil switch contactor ON/OFF is completed and
the gate is turned ON.
The standard setting is "120".
---Setting range---
0 to 999 (Short-time rated %)
Set the time to detect the speed excessive error alarm.
Set the time required to the machine.
The standard setting is "12".
---Setting range---
0 to 60 (s)
Set the magnetic pole shift amount of IPM spindle motor.
During DC excitation of the initial setup: Set the same value displayed in the "AFLT gain" on the NC monitor
screen in SP225/bit4=1.
When not using, set to "0".
---Setting range---
-18000 to 18000 (electrical angle 0.01°)
Not used. Set to "0".
Not used. Set to "0".
#13107-
13111 SP107-SP111
#13112 SP112 IFF OMR-FF current feed forward gain
#13113 SP113 OPLP Current command value for open loop
#13114 SP114 MKT Coil changeover gate cutoff timer
#13115 SP115 MKT2 Coil changeover current limit timer
#13116 SP116 MKIL Coil changeover current limit value
#13117 SP117 SETM Excessive speed deviation timer
(PR) #13118 SP118 MSFT Magnetic pole shift amount
#13119 SP119
#13120 SP120