Mitsubishi Electric C80 Series, Manual

Page: 404 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
387 IB-1501279-H
Select how to handle the absolute position data during automatic handle interrupt.
0: Absolute position data will be renewed if manual ABS switch is ON. If it is OFF, data won't be renewed.
1: Follow the "intabs" state when "#1061 intabs" is enabled
Select how to handle the spindle rotation speed clamp function with the G92/G50S command.
0: G92/G50S command is handled as a clamp command only in the G96 state (during constant surface
speed control).
G92S will be handled as normal S command in G97 state (constant surface speed OFF).
1: The S command in the same block as G92/G50 is constantly handled as a clamp command
Specify the type of spindle min. rotation speed clamp value.
0: Rotation speed setting
1: Output voltage coefficient setting
Set "#3023 smini" according to this type setting.
Select whether to decelerate at the arc entrance or exit.
0: Not decelerate
1: Decelerate
Select whether to perform a deceleration check or in-position check at the hole bottom in a hole drilling cycle.
This parameter is enabled only for a hole drilling cycle in which no dwell command can be issued at the hole
bottom.
0: Perform no deceleration check and in-position check
1: Perform deceleration check
2: Perform in-position check
Not used. Set to "0".
Not used. Set to "100".
Not used. Set to "100".
Not used. Set to "0".
Not used. Set to "0".
Select whether to enable or disable RIO connection detection.
0: Enable
1: Disable
If your I/O consists of only cards such as CC-LINK, setting this parameter to "1" will avoid the RIO commu-
nication cutoff alarm.
Select whether to enable or disable the automatic tuning function.
0: Disable
1: Enable
(Note) Enable this parameter when using MS Configurator.
#1145 I_abs Manual ABS parameter
#1146 Sclamp Spindle rotation speed clamp function
#1147 smin_V Minimum spindle rotation speed clamp type
#1149 cireft Arc deceleration speed change
#1153 FixbDc Hole bottom deceleration check
(PR) #1154 pdoor
#1155 DOOR_m
#1156 DOOR_s
#1157 F0atrn
#1158 F0atno
(PR) #1163 No rio RIO connection detection invalid
(PR) #1164 ATS Automatic tuning function