Mitsubishi Electric C80 Series, Manual

Page: 634 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
617 IB-1501279-H
16.10 Spindle-type Servo Parameters
[Exclusive for spindle-mode servo motor]
bit0 Selection of position loop gain when C axis is selected
0: Use the position loop gain (#52203 SV003, #52204 SV004, #52257 SV057)
1: Use the spindle sync control position loop gain (#52249 SV049, #52250 SV050, #52258 SV058)
bit1 Selection of sync tap cycle position loop gain
0: Use the position loop gain (#52203 SV003, #52204 SV004, #52257 SV057)
1: Use the spindle sync control position loop gain (#52249 SV049, #52250 SV050, #52258 SV058)
---Setting range---
00 to FFFF (HEX)
[Exclusive for spindle-mode servo motor]
Specify the motor rotation speed at which zero speed detection is carried out. When the actual motor speed
drops to the specified speed or below, the zero speed detection signal turns ON. The standard setting value
is "50", which is applied when 0 is set in this parameter.
---Setting range---
0 to 1000(r/min)
[Exclusive for spindle-mode servo motor]
Specify the motor speed at which speed detection is carried out.
When the actual motor speed drops to the specified speed or below, the speed detection signal turns ON.
The standard setting value is 10% of "#3001 slimt 1", and is applied when 0 is set in this parameter.
---Setting range---
0 to 32767(r/min)
[Exclusive for spindle-mode servo motor]
Specify the torque limit value to be applied when Torque limit (Control input 1/bitA,9,8)=001.
---Setting range---
0 to 999 (Short-time rated %)
[Exclusive for spindle-mode servo motor]
Specify the torque limit value to be applied when Torque limit (Control input 1/bitA,9,8)=010.
---Setting range---
0 to 999 (Short-time rated %)
[Exclusive for spindle-mode servo motor]
Specify the torque limit value to be applied when Torque limit (Control input 1/bitA,9,8)=011.
---Setting range---
0 to 999 (Short-time rated %)
The description and setting range for these parameters are the same as Servo parameters "SV001" to
"SV256". Refer to "Servo Parameters" for details.
(Note) Set the same value to #52203 SV003(PGN) for the basic and synchronous spindles in spindle syn-
chronization.
#52001 SVSPEC Spindle-mode servo: Specification
#52002 svzsp Spindle-mode servo: Motor zero speed
#52003 svsdts Spindle-mode servo: Speed detection set value
#52004 svtlm1 Spindle-mode servo: Torque limit 1
#52005 svtlm2 Spindle-mode servo: Torque limit 2
#52006 svtlm3 Spindle-mode servo: Torque limit 3
#52201-52456 SV001-SV256 Spindle-type Servo Parameters