Mitsubishi Electric C80 Series, Manual

Page: 494 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
477 IB-1501279-H
Set the tolerance between the commanded stroke and actual stroke.
Compensation will be applied during chopping so that the result of [command width - maximum stroke of top
or bottom dead point/ 2] will be within this tolerance.
---Setting range---
0 to 10.000 (mm)
Set the clamp speed in chopping operation.
When "0" is set, the clamp speed will be determined by "#2002 clamp".
---Setting range---
0 to 60000 (mm/min)
Set the No. for each axis in order from the 1st automatically returning axis to the restart position.
When "0" is set, the axis will not return.
Note that when "0" is set for all axes, all of the axes will return simultaneously.
(Note) On the absolute position system, when performing the restart search just after power ON, and when
the axis that is the order 0 is moved by the follow-up, an operation error(M01 0128) may occur.
---Setting range---
0 to 16
Select how to operate the unidirectional positioning when the positioning command (G00) is issued.
0: Carry out unidirectional positioning according to the command and modal.
1: Carry out unidirectional positioning regardless of the command and modal.
Set "1" for the axis to carry out the unidirectional positioning at every positioning command, regardless of
whether the unidirectional positioning command and modal are issued.
<Related parameters>
"#8209 G60 SHIFT" and "#2076 index_x"
Set the maximum feed rate for each axis when the external deceleration signal is ON.
This parameter is enabled when "#1239 set11/bit6 (External deceleration axis compliance valid)" is set to "1".
---Setting range---
0 to 1000000 (mm/min)
Set the polarity of synchronous axis with respect to basic axis to the bit corresponding to each axis.
0: Polarity with respect to basic axis is positive
1: Polarity with respect to basic axis is negative
---Setting range---
0 to FF (hexadecimal)
Set the basic axis for synchronous control with the 2nd axis name (axname2).A numerical character cannot
be set as the 1st character.
---Setting range---
1st character:A to Z
2nd character:A to Z, 1 to 9
#2080 chwid Bottom dead center position width
#2081 chclsp Maximum chopping speed
#2082 a_rstax Restart position return order
#2084 G60_ax Unidirectional positioning operation selection
#2086 exdcax External deceleration speed
#2087 syncnt Synchronization/super-imposition control setting for
each axis
#2088 bsax_sy Reference axis for synchronous control