Mitsubishi Electric C80 Series, Manual

Page: 357 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
340 IB-1501279-H
15.16 Tolerance Parameters[M8]
Specify a tolerance (tolerable error) to be used under tolerance control.
Set a tolerable error for fine segment program created by CAM.
(Usually around 0.01(mm))
If 0.000 is set, it is operated with the tolerance of 0.01(mm).
When designating the tolerance amount with the ", K address", this parameter is not used.
---Setting range---
0.000 to 100.000 (mm)
Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
When high-accuracy control time constant expansion is valid, set the maximum of cutting feed clamp speed
of each axis.
---Setting range---
1 to 999999 (mm/min)
Set a cutting feed time constant when applying pre-interpolation acceleration/deceleration.
When set to "0", the time constant will be clamped at 1ms.
---Setting range---
Without high-accuracy control time constant expansion: 1 to 5000 (ms)
With high-accuracy control time constant expansion: 1 to 30000 (ms)
Cutting feed Acc Cutting feed acceleration
Displays cutting feed acceleration.
Set the filter time constant for smoothly changing the acceleration rate for the cutting feed acceleration/de-
celeration in pre-interpolation acceleration/deceleration.
- Notch frequency Hz
Displays the notch frequency (Hz) for the S-pattern filter set in "#1568 SfiltG1" (G01 soft acceleration/decel-
eration filter).
---Setting range---
0 to 200 (ms)
#2659 tolerance Tolerance
#1206 G1bF Maximum speed
#1207 G1btL Time constant
#1568 SfiltG1 G01 soft acceleration/deceleration filter
G1btL
G1bF
Time
Speed