Mitsubishi Electric C80 Series, Manual

Page: 578 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
561 IB-1501279-H
Set the linear acceleration/deceleration time constant for zero point return control (#3106/bit4,8) which is au-
tomatically started at the time of switching orientation control, C axis control and synchronous tapping control
when gear 01 is selected. The inclination is determined by the ratio to limit rotation speed (slimit2). Set the
sufficiently large value compared to the acceleration/deceleration time constant with S command (sp_t2) so
that the output torque is not saturated. When executing C axis zero point return manually, it depends on the
axis specification parameter.
---Setting range---
0 to 30000 (ms)
Set the linear acceleration/deceleration time constant for zero point return control (#3106/bit4,8) which is au-
tomatically started at the time of switching orientation control, C axis control and synchronous tapping control
when gear 10 is selected. The inclination is determined by the ratio to limit rotation speed (slimit3). Set the
sufficiently large value compared to the acceleration/deceleration time constant with S command (sp_t3) so
that the output torque is not saturated. When executing C axis zero point return manually, it depends on the
axis specification parameter.
---Setting range---
0 to 30000 (ms)
Set the linear acceleration/deceleration time constant for zero point return control (#3106/bit4,8) which is au-
tomatically started at the time of switching orientation control, C axis control and synchronous tapping control
when gear 11 is selected. The inclination is determined by the ratio to limit rotation speed (slimit4). Set the
sufficiently large value compared to the acceleration/deceleration time constant with S command (sp_t4) so
that the output torque is not saturated. When executing C axis zero point return manually, it depends on the
axis specification parameter.
---Setting range---
0 to 30000 (ms)
When performing high-speed synchronous tapping control(#1281/bit5), set the reduction rate of the time con-
stant compared to the time constant in normal synchronous tapping.
(Setting "0" or "100" will be regarded as reduction rate zero, so the time constant won't be reduced.)
E.g.) When set to "10", time constant in high-speed synchronous tapping will be 90% of that in normal syn-
chronous tapping.
---Setting range---
0 to 100(%)
Select the validity of turret indexing.
0: Invalid
1: Valid
Set the number of teeth on the turret side when the gear selection command (control input 4/bit6, 5) is set to
00. Set a value of GRC so that the ratio of GRC to the spindle side gear ratio (#13057 SP057) will be 1:N (an
integer).
If GRC is set to "0", it will be regarded as "1".
---Setting range---
0 to 32767
Set the turret end indexing speed when in turret indexing.
When this parameter is set to 0, it follows the value set for Orientation command speed (#3107).
---Setting range---
0 to 32767(r/min)
#3116 sp2_t2 Time constant in orientation/interpolation mode auto-
matic reference position return (Gear: 01)
#3117 sp2_t3 Time constant in orientation/interpolation mode auto-
matic reference position return (Gear: 10)
#3118 sp2_t4 Time constant in orientation/interpolation mode auto-
matic reference position return (Gear: 11)
#3120 staptr Time constant reduction rate in high-speed synchro-
nous tapping
#3121 tret Turret indexing
#3122 GRC Turret side gear ratio
#3123 tret_spd Turret indexing speed