Mitsubishi Electric C80 Series, Manual

Page: 518 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
501 IB-1501279-H
Set the minimum value of time constant when changing time constant during acceleration and deceleration
of G0 command.
Set the time constant which was adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Set the minimum value when changing time constant during acceleration and deceleration of G1 command
after interpolation.
Set the time constant which was adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Set the minimum value when changing time constant during acceleration and deceleration of G1 command
before interpolation.
Set the time constant which is adjusted when workpiece is not attached.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G0 command based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G1 command after interpolation based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Set the changing amount of time constant when changing time constant during acceleration and deceleration
of G1 command before interpolation based on the estimated inertia ratio.
Note that when 0 is set, the value will be 10 (default).
---Setting range---
0 to 4000(ms)
Specify a tolerance (tolerable error) to be used under tolerance control.
Set a tolerable error for fine segment program created by CAM.
(Usually around 0.01(mm))
If 0.000 is set, it is operated with the tolerance of 0.01(mm).
When designating the tolerance amount with the ", K address", this parameter is not used.
---Setting range---
0.000 to 100.000 (mm)
#2653 RT2G0tL RT2: Minimum value of G0 acce/dece time constant
#2654 RT2G1tLA RT2: Minimum value of acce/dece time constant after G1
interpolation
#2655 RT2G1tLB RT2: Minimum value of acce/dece time constant before
G1 interpolation
#2656 RT2 G0rng RT2: Changing amount of G0 acce/dece time constant
#2657 RT2G1rngA RT2: Changing amount of acce/dece time constant after
G1 interpolation
#2658 RT2G1rngB RT2: Changing amount of acce/dece time constant before
G1 interpolation
#2659 tolerance Tolerance