Mitsubishi Electric C80 Series, Manual

Page: 644 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
627 IB-1501279-H
16.12 PLC Timer
Set the time for the timer used in the PLC program (ladder).
The 10ms timer and 100ms timer are identified by the command used.
(Note1) This setting value is valid when bit selection parameter "#6449/bit0" is set to "0".
(Note2) Setting the timer setting value from the setting and display unit
The timer T setting value can be set with the following two methods.
- Method to validate the setting value (Kn) programmed with the sequence program (fixed timer)
- Method to validate the setting value set from the setting and display unit (variable timer)
(Note3) As described bellow, the setting method of timer T and No. of points can be set with the bit selection
parameters (#6454/bit0 to bit3).
- #6454/bit0=0, bit1=0, bit2=0, bit3=0
No. of points: 0
Range: None
Setting method: All fixed timers
- #6454/bit0=1, bit1=0, bit2=0, bit3=0
No. of points: 100
Range: #16000 to #16099
Setting method: Set above range with variable timers.
- #6454/bit0=0, bit1=1, bit2=0, bit3=0
No. of points:200
Range: #16000 to #16199
Setting method: Set above range with variable timers.
- #6454/bit0=1, bit1=1, bit2=0, bit3=0
No. of points: 300
Range: #16000 to #16299
Setting method: Set above range with variable timers.
- #6454/bit0=0, bit1=0, bit2=1, bit3=0
No. of points: 400
Range: #16000 to #16399
Setting method: Set above range with variable timers.
- #6454/bit0=1, bit1=0, bit2=1, bit3=0
No. of points: 500
Range: #16000 to #16499
Setting method: Set above range with variable timers.
- #6454/bit0=0, bit1=1, bit2=1, bit3=0
No. of points: 600
Range: #16000 to #16599
Setting method: Set above range with variable timers.
- #6454/bit0=1, bit1=1, bit2=1, bit3=0
No. of points: All points
Range: #16000 to #16703
Setting method: All variable timers
---Setting range---
0 to 32767( x 10ms or x 100ms)
#16000-
16703 T0 - T703 PLC timer <10ms/100ms>