Section 10: KPulse (for Keithley Pulse Cards)
Model 4200A-SCS Parameter Analyzer Reference Manual
10-12
4200A-901-01 Rev. C / February 2017
6. To change a waveform sequence, select a waveform in the Sequencer and select
Move Up
or
Move Down
.
7.
Delete
buttons - After selecting a waveform in the Scratch Pad or Sequencer, select the
appropriate Delete button to remove it. Note that deleting a waveform from the Scratch Pad also
removes it from the Sequencer.
8. Set the
Time per Point
(in seconds). This is the time interval between each point in the
waveforms.
9. Save the waveforms as a Keithley Arb File (.kaf). By default,
.kaf
files are saved in the folder:
C:\s4200\kiuser\KPuIse\ArbFiles
10. Use
Save As
to name the file and save it.
11. After any subsequent changes, select
Save
to overwrite the
.kaf
file.
Custom Arb file operation: Load waveform and turn on output
To load the waveform and turn on the output:
1. Select a pulse card tab.
2. Select
Custom File
Arb
.
3. Browse for a
Waveform File
and then select and load the
.kaf
file.
Figure 477: Custom File Arbe operation: Load waveform and turn on output
