Monitoring
Enable the Wi-Fi scanner
LR54 User Guide
963
9. Add collectors:
a. Add a collector:
(config)> add monitoring netflow collector end
(config monitoring netflow collector 0)>
b. Set the IP address of the collector:
(config monitoring netflow collector 0)> address
ip_address
(config monitoring netflow collector 0)>
c. (Optional) Set the port used by the collector:
(config monitoring netflow collector 0)> port
port
(config monitoring netflow collector 0)>
d. (Optional) Set a label for the collector:
(config monitoring netflow collector 0)> label "This is a collector."
(config monitoring netflow collector 0)>
Repeat to add additional collectors.
10. Save the configuration and apply the change:
(config monitoring netflow collector 0)> save
Configuration saved.
>
11. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Enable the Wi-Fi scanner
The Wi-Fi scanner allows you to configure your device to detect Wi-Fi-enabled devices that are nearby,
and then opens an SSH port that remote hosts can access to read basic information about those
devices.
For users to view the output of the Wi-Fi scanner, they must be a member of an authentication group
that has
Wi-Fi scanner access
enabled. See
for authentication group
configuration information.
Required configuration
n
Enable the Wi-Fi scanner.
n
The wireless radio to use for scanning.
Additional configuration
n
The SSH port used by the Wi-Fi scanner for reporting information to the remote host.
n
The Wi-Fi channels to be scanned.
