Wi-Fi
Configure a Wi-Fi access point with enterprise security
LR54 User Guide
291
b. Set the appropriate radio:
(config)> network wifi ap digi_ap1 radio wifi1
(config)>
12. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
(config)> network wifi ap digi_ap1 encryption group_rekey
value
(config)>
where
value
is any number of days, hours, minutes, or seconds, and takes the format
number
{
d|h|m|s
}.
For example, to set
group rekey interval
to ten minutes, enter either
10m
or
600s
:
(config)> network wireless ap digi_ap1 encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to
0
. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
and
for more information.
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
