Serial port
Configure PPP dial-in mode
LR54 User Guide
235
3. Click to expand the name of the port that you want to configure, for example,
Port 1
.
The serial port is enabled by default. To disable, toggle off
Enable
.
4. For
Mode
, select
PPP-Dial-in
. The default is
Login
.
5. (Optional) For
Label
, enter a label that will be used when referring to this port.
6. For
Baud rate
, select the baud rate used by the device to which you want to connect. The
default is
115000
.
7. For
Flow control
, select the type of flow control used by the device to which you want to
connect. The default is
None
.
8. For
Idle timeout
, type the amount of time that the active session can be idle before the
session is disconnected.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number
{
w|d|h|m|s
}.
For example, to set
Idle timeout
to ten minutes, enter
10m
or
600s
.
9. Click to expand
PPP dial-in
.
10. For
Local IP address
, type the IP address assigned to this interface.
11. For
Remote IP address
, type the IP address assigned to the remote peer.
12. For
Authentication method
, select the method used to authenticate the remote peer. Allowed
values are:
n
None
: No authentication is required.
n
Automatic
: Attempt to authenticate using CHAP first, and then PAP.
n
CHAP
: Use Challenge Handshake Authentication Protocol (CHAP) to authenticate.
n
PAP
: Use Password Authentication Protocol (PAP) to authenticate.
