Interfaces
Wide Area Networks (WANs)
LR54 User Guide
108
The default is
Automatic
.
5. (Optional) For
Authentication method
, select one of the following:
n
None
: No authentication is required.
n
Automatic
: The device will attempt to connect using CHAP first, and then PAP.
n
CHAP
: Uses the Challenge Handshake Authentication Profile (CHAP) to authenticate.
n
PAP
: Uses the Password Authentication Profile (PAP) to authenticate.
If
Automatic
,
CHAP
, or
PAP
is selected, enter the
Username
and
Password
required to
authenticate.
The default is
None
.
6. To add additional APNs, for
Add APN
, click
and repeat the preceding instructions.
7. (Optional) To configure the device to bypass its preconfigured APN list and only use the
configured APNs, enable
APN list only
.
8. Click
Apply
to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click
Actions
>
Open Console
, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface wwan modem apn 0 apn
value
(config)>
where
value
is the APN for the SIM card.
4. (Optional) To add additional APNs:
a. Use the
add
command to add a new APN entry. For example:
(config)> add network interface wwan modem apn end
(config network interface wwan modem apn 1)>
