Command line interface
Configuration mode
LR54 User Guide
1069
n
Move to the location in the configuration and enter the
revert
command without the
path
parameter. For example:
1. Change to the auth method node:
(config)> auth method
(config auth method)>
2. Enter the
revert
command:
(config auth method)> revert
(config auth method)>
3. Save the configuration and apply the change:
(config auth method)> save
Configuration saved.
>
4. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access
selection menu
. Type
quit
to disconnect from the device.
n
You can also use a combination of both of these methods:
1. Change to the
auth
node:
(config)> auth
(config auth)>
2. Enter the
revert
command with the
path
set to
method
:
(config auth)> revert method
(config auth)>
3. Save the configuration and apply the change:
(config auth)> save
Configuration saved.
>
4. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access
selection menu
. Type
quit
to disconnect from the device.
Enter strings in configuration commands
For string parameters, if the string value contains a space, the value must be enclosed in quotation
marks. For example, to assign a descriptive name for the device using the
system
command, enter:
(config)> system description "Digi LR54"
Example: Create a new user by using the command line
In this example, you will use the LR54 command line to create a new user, provide a password for the
user, and assign the user to authentication groups.
