Services
Location information
LR54 User Guide
631
5. For
Location update interval
, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number
{
w|d|h|m|s
}.
For example, to set
Location update interval
to ten minutes, enter
10m
or
600s
.
6. For information about configuring
Location sources
, see the following:
a. To accept location information from an external location-enabled server, see
device to accept location messages from external sources
.
b. To set a static location for the device, see
Configure the device to use a user-defined static
If multiple location sources are enabled at the same time, the device's location will be
determined based on the order that the location sources are listed here.
7. For information about configuring
Destination servers
, see
Forward location information to a
.
8. For information about configuring
Geofence
, see
9. Click
Apply
to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click
Actions
>
Open Console
, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSS module:
n
To enable the module:
(config)> service location gnss true
(config)>
n
To disable the module:
(config)> service location gnss false
(config)>
4. Set the amount of time that the LR54 device will wait before polling location sources for
updated location data:
(config)> service location interval
value
(config)>
where
value
is any number of hours, minutes, or seconds, and takes the format
number
{
h|m|s
}.
For example, to set
interval
to ten minutes, enter either
10m
or
600s
:
