Hotspot
Hotspot configuration
LR54 User Guide
335
d. Create an interface for the bridge:
i. Click
Configuration
>
Network
>
Interfaces
.
ii. For
Add Interface
, create a new interface and click
.
iii. For
Device
, select the bridge created above.
iv. Click to expand
IPv4
.
v. For Address, enter an IP address and subnet mask for the LAN. This IP address must
be unique from all other interfaces.
Note
This IP address is not the IP address of the hotspot. The hotspot IP address is
configured during hotspot configuration.
5. Click
Network
>
Hotspots
.
6. For
Add Hotspot
, enter a name for the hotspot and click
.
The new hotspot configuration appears.
7. Hotspots are enabled by default when they are created. To disable, toggle off
Enable hotspot
.
8. For
Zone
, leave at the default setting of
hotspot
. The
hotspot
firewall zone provides the
necessary firewall rules for hotspot functionality.
9. For
Device
, select an access point, and Ethernet port, or a bridge.
10. For
Authentication Mode
, select one of the following:
n
Click-through
: Requires each user to accept the terms and conditions.
n
Local shared password
: Requires each user to enter a password. This password is
validated locally on the LR54 device, and the password is the same for all users.
See
Configure the hotspot to use local shared password authentication
for information
about configuring hotspot for local shared password authentication.
