Cisco Catalyst 2960 Series, Configuration Manual

Page: 2023 / 2288

Set _cerrno
No
Event_reqinfo
"event_id %u event_type %u event_type_string {%s} %u event_pub_sec %u event_pub_msec %u
event_severity {%s}" "oid {%s} oid_val {%s} src_ip_addr {%s} dest_ip_addr {%s} x_x_x_x_x
(varbinds) {%s} trunc_vb_buf {%s} trap_oid {%s} enterprise_oid {%s} generic_trap %u
specific_trap %u"
Description Event Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id. event_id
Type of event.
event_type
An ASCII string that represents the name of the event
for this event type. event_type_string
The time, in seconds and milliseconds, when the event
was published to the EEM.
event_pub_sec event_pub_msec
An user specified object ID. oid
An user specified object ID value.
oid_val
The source IP address of the SNMP protocol data unit
(PDU). src_ip_addr
The destination IP address of the SNMP PDU.
dest_ip_addr
The SNMP PDU varbind information. x_x_x_x_x (varbinds)
Indicates the trap OID value.
trap_oid
Indicates the enterprise OID value. enterprise_oid
Indicates one of a number of generic trap types. There
are seven generic trap numbers zero to six. generic_trap
Indicates one of a number of specific trap codes. specific_trap
event_register_snmp_object
Registers for a Simple Network Management Protocol (SNMP) object event. Use this Tcl command extension
to replace the value when an SNMP with the specified SNMP-object ID (OID) is encountered on a specific
interface or address.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1941
event_register_snmp_object