Cisco Catalyst 2960 Series, Configuration Manual

Page: 253 / 2288

Message timers and state transitions resulting from messages being sent or received are the same as those of
IGMPv2 messages. MLD messages that do not have valid link-local IPv6 source addresses are ignored by
MLD routers and switches.
MLD Queries
The switch sends out MLD queries, constructs an IPv6 multicast address database, and generates MLD
group-specific and MLD group-and-source-specific queries in response to MLD Done messages. The switch
also supports report suppression, report proxying, Immediate-Leave functionality, and static IPv6 multicast
group address configuration.
When MLD snooping is disabled, all MLD queries are flooded in the ingress VLAN.
When MLD snooping is enabled, received MLD queries are flooded in the ingress VLAN, and a copy of the
query is sent to the CPU for processing. From the received query, MLD snooping builds the IPv6 multicast
address database. It detects multicast router ports, maintains timers, sets report response time, learns the querier
IP source address for the VLAN, learns the querier port in the VLAN, and maintains multicast-address aging.
When the IPv6 multicast router is a Catalyst 6500 switch and you are using extended VLANs (in the range
1006 to 4094), IPv6 MLD snooping must be enabled on the extended VLAN on the Catalyst 6500 switch
in order for the Catalyst 2960, 2960-S, 2960-C, 2960-X or 2960-CX switch to receive queries on the
VLAN. For normal-range VLANs (1 to 1005), it is not necessary to enable IPv6 MLD snooping on the
VLAN on the Catalyst 6500 switch. Note
When a group exists in the MLD snooping database, the switch responds to a group-specific query by sending
an MLDv1 report. When the group is unknown, the group-specific query is flooded to the ingress VLAN.
When a host wants to leave a multicast group, it can send out an MLD Done message (equivalent to IGMP
Leave message). When the switch receives an MLDv1 Done message, if Immediate- Leave is not enabled,
the switch sends an MASQ to the port from which the message was received to determine if other devices
connected to the port should remain in the multicast group.
Multicast Client Aging Robustness
You can configure port membership removal from addresses based on the number of queries. A port is removed
from membership to an address only when there are no reports to the address on the port for the configured
number of queries. The default number is 2.
Multicast Router Discovery
Like IGMP snooping, MLD snooping performs multicast router discovery, with these characteristics:
• Ports configured by a user never age out.
• Dynamic port learning results from MLDv1 snooping queries and IPv6 PIMv2 packets.
• If there are multiple routers on the same Layer 2 interface, MLD snooping tracks a single multicast
router on the port (the router that most recently sent a router control packet).
• Dynamic multicast router port aging is based on a default timer of 5 minutes; the multicast router is
deleted from the router port list if no control packet is received on the port for 5 minutes.
• IPv6 multicast router discovery only takes place when MLD snooping is enabled on the switch.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
171
Information About Configuring IPv6 MLD Snooping