Cisco Catalyst 2960 Series, Configuration Manual

Page: 1812 / 2288

SUMMARY STEPS
1.
enable
2. configure terminal
3.
event manager applet applet-name
4. Do one of the following:
• event snmp oid oid-value get-type { exact | next } entry-op operator entry-val
entry-value [ exit-comb | and }] [ exit-op operator ] [ exit-val exit-value ] [ exit-time exit-time-value ]
poll-interval poll-int-value
5.
action label info type snmp var variable-name oid oid-value oid-type oid-type-value
6.
action label info type snmp trap enterprise-oid enterprise-oid-value generic-trapnum
generic-trap-number specific-trapnum specific-trap-number trap-oid trap-oid-value trap-var
trap-variable
7. action label info type snmp inform trap-oid trap-oid-value trap-var trap-variable community
community-string ipaddr ip-address
8. exit
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. enable Step 1
Example:
Device> enable
• Enter your password if prompted.
Enters global configuration mode. configure terminal
Example:
Device# configure terminal
Step 2
Registers the applet with the event manager server and
enters applet configuration mode. event manager applet applet-name
Example:
Device(config)# event manager applet snmp
Step 3
Specifies the event criteria that cause the EEM applet
to run. Do one of the following: Step 4
• event snmp oid oid-value get-type { exact | next }
entry-op operator entry-val entry-value [ exit-comb | • In this example, an EEM event is triggered when
free memory falls below the value of 5120000.
and }] [ exit-op operator ] [ exit-val exit-value ] [ exit-time
exit-time-value ]
poll-interval poll-int-value
• Exit criteria are optional, and if not specified, event
monitoring is reenabled immediately.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1730
How to Write EEM Policies Using the Cisco IOS CLI