Cisco Catalyst 2960 Series, Configuration Manual

Page: 675 / 2288

DETAILED STEPS
Purpose Command or Action
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 1
Creates an IP standard or extended ACL, an IPv6 ACL for IP traffic,
or a Layer 2 MAC ACL for non-IP traffic, repeating the command
as many times as necessary. Use one of the following:
Step 2
• access-list access-list-number { deny | permit }
source [ source-wildcard ]
When creating an access list, remember that, by default, the end of
the access list contains an implicit deny statement for everything if
it did not find a match before reaching the end.
• access-list access-list-number { deny | permit }
protocol source [ source-wildcard ] destination
[ destination-wildcard ]
• ipv6 access-list access-list-name { deny |
permit } protocol
{ source-ipv6-prefix/prefix-length |
any
|
host
source-ipv6-address } [ operator
[ port-number ]] { destination-ipv6-prefix /
prefix-length | any | host
destination-ipv6-address } [ operator
[ port-number ]] [ dscp value ] [ fragments ] [ log ]
[ log-input ] [ routing ] [ sequence value ]
[
time-range name
]
•
mac access-list extended name
{
permit
|
deny
} {
host src-MAC-addr mask
|
any
|
host
dst-MAC-addr | dst-MAC-addr mask } [ type
mask ]
Example:
Switch(config)# access-list 103 permit ip
any
any dscp 10
Creates a class map, and enters class-map configuration mode.
class-map
[
match-all
|
match-any
] class-map-name Step 3
Example:
Switch(config)# class-map class1
By default, no class maps are defined.
• (Optional) Use the
match-all
keyword to perform a logical-AND
of all matching statements under this class map. All match
criteria in the class map must be matched.
• (Optional) Use the match-any keyword to perform a logical-OR
of all matching statements under this class map. One or more
match criteria must be matched.
• For class-map-name , specify the name of the class map.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
593
How to Configure QoS