Cisco Catalyst 2960 Series, Configuration Manual

Page: 236 / 2288

Applying IGMP Profiles
To control access as defined in an IGMP profile, you have to apply the profile to the appropriate interfaces.
You can apply IGMP profiles only to Layer 2 access ports; you cannot apply IGMP profiles to routed ports
or SVIs. You cannot apply profiles to ports that belong to an EtherChannel port group. You can apply a profile
to multiple interfaces, but each interface can have only one profile applied to it.
Follow these steps to apply an IGMP profile to a switch port:
SUMMARY STEPS
1. enable
2. configure terminal
3.
interface interface-id
4. ip igmp filter profile number
5.
end
6.
show running-config
7. copy running-config startup-config
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if
prompted. enable
Example:
Switch> enable
Step 1
Enters the global configuration mode. configure terminal
Example:
Switch#
configure terminal
Step 2
Specifies the physical interface, and enters interface
configuration mode. The interface must be a Layer 2 port that
does not belong to an EtherChannel port group. interface interface-id
Example:
Switch(config)# interface
Step 3
gigabitethernet1/0/1
Applies the specified IGMP profile to the interface. The range
is 1 to 4294967295. ip igmp filter profile number
Example:
Switch(config-if)# ip igmp filter 321
Step 4
To remove a profile from an interface, use the
no ip
igmp filter profile number
interface configuration
command.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
154
How to Configure IGMP Snooping and MVR