Cisco Catalyst 2960 Series, Configuration Manual

Page: 106 / 2288

When set to desired , an interface can operate with an attached device that is required to send flow-control
packets or with an attached device that is not required to but can send flow-control packets.
These rules apply to flow control settings on the device:
• receive on (or desired ): The port cannot send pause frames but can operate with an attached device that
is required to or can send pause frames; the port can receive pause frames.
• receive off : Flow control does not operate in either direction. In case of congestion, no indication is
given to the link partner, and no pause frames are sent or received by either device.
For details on the command settings and the resulting flow control resolution on local and remote ports,
see the
flowcontrol interface configuration command in the command reference for this release.
Note
How to Configure Interface Characteristics
Configuring Interfaces
These general instructions apply to all interface configuration processes.
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if prompted. enable Step 1
Example:
Switch> enable
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Identifies the interface type, the switch number (only on stacking-capable
switches), and the number of the connector. interface
Example:
Switch(config)# interface
Step 3
You do not need to add a space between the interface type and
the interface number. For example, in the preceding line, you can
specify either
gigabitethernet 1/0/1 , gigabitethernet1/0/1 ,
gi 1/0/1 , or gi1/0/1 .
Note
gigabitethernet1/0/1
Switch(config-if)#
Defines the protocols and applications that will run on the interface. The
commands are collected and applied to the interface when you enter another
interface command or enter
end to return to privileged EXEC mode.
Follow each interface command with the
interface configuration commands that the
interface requires.
Step 4
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
24
How to Configure Interface Characteristics