Cisco Catalyst 2960 Series, Configuration Manual

Page: 771 / 2288

Purpose Command or Action
Example:
Switch(config-nd-inspection)# default limit
address-count
Verifies the ND Inspection Configuration without
exiting ND inspection configuration mode. do show ipv6 nd inspection policy policy_name
Example:
Switch(config-nd-inspection)# do show ipv6 nd
inspection policy example_policy
Step 12
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Attach an IPv6 Neighbor Discovery Inspection Policy to an Interface
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 ND Inspection policy to an interface
or VLANs on an interface :
SUMMARY STEPS
1.
configure terminal
2. interface Interface_type stack/module/port
3.
ipv6 nd inspection [ attach-policy policy_name [ vlan { vlan_ids | add vlan_ids | except vlan_ids | none
| remove vlan_ids | all } ] | vlan [ { vlan_id s | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all } ]
4.
do show running-config
DETAILED STEPS
Purpose Command or Action
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 1
Specifies an interface type and identifier; enters the
interface configuration mode. interface Interface_type stack/module/port
Example:
Switch(config)# interface gigabitethernet 1/1/4
Step 2
Attaches the Neighbor Discovery Inspection policy
to the interface or the specified VLANs on that ipv6 nd inspection [ attach-policy policy_name [ vlan { vlan_ids
| add vlan_ids | except vlan_ids | none | remove vlan_ids | all }
Step 3
interface. The default policy is attached if the
attach-policy option is not used.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
689
How to Configure an IPv6 Neighbor Discovery Inspection Policy