Cisco Catalyst 2960 Series, Configuration Manual

Page: 1698 / 2288

Use the no form of this command to disable testing.
By default, health monitoring is disabled, but the Switch generates a syslog message when a test fails.
Follow these steps to configure and enable the health-monitoring diagnostic tests:
SUMMARY STEPS
1. enable
2.
configure terminal
3.
diagnostic monitor interval switch number test
{ name | test-id | test-id-range |
all
} hh:mm:ss milliseconds
day
4. diagnostic monitor syslog
5.
diagnostic monitor threshold switch number test { name | test-id | test-id-range | all } failure count count
6. diagnostic monitor switch number test { name | test-id | test-id-range | all }
7. end
8.
show running-config
9. copy running-config startup-config
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if prompted. enable Step 1
Example:
Switch> enable
Enters the global configuration mode. configure terminal
Example:
Switch#
configure terminal
Step 2
Configures the health-monitoring interval of the specified tests. diagnostic monitor interval switch number
test
{ name | test-id | test-id-range |
all
}
hh:mm:ss milliseconds day
Step 3
The switch number keyword is supported only on stacking switches.
When specifying the tests, use one of these parameters:
Example:
Switch(config)# diagnostic monitor
• name — Name of the test that appears in the
show diagnostic content
command output.
interval switch 2 test 1 12:30:00 750
5
•
test-id
—
ID number of the test that appears in the show diagnostic
content command output.
• test-id-range — ID numbers of the tests that appear in the show
diagnostic content
command output.
•
all
—
All of the diagnostic tests.
When specifying the interval, set these parameters:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1616
How to Configure Online Diagnostics