Cisco Catalyst 2960 Series, Configuration Manual

Page: 150 / 2288

Purpose Command or Action
Example:
Switch> enable
Enters global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the network-policy profile number, and enter network-policy
configuration mode. The range is 1 to 4294967295.
network-policy profile profile number
Example:
Switch(config)#
network-policy profile
Step 3
1
Configures the policy attributes: { voice | voice-signaling } vlan [ vlan-id { cos
cvalue |
dscp dvalue
}] | [[
dot1p
{
cos cvalue
|
dscp dvalue
}] |
none
|
untagged
]
Step 4
• voice — Specifies the voice application type.
Example:
Switch(config-network-policy)#
voice vlan
•
voice-signaling
—
Specifies the voice-signaling application type.
•
vlan
—
Specifies the native VLAN for voice traffic.
• vlan-id — (Optional) Specifies the VLAN for voice traffic. The
range is 1 to 4094.
100 cos 4
•
cos cvalue
—
(Optional) Specifies the Layer 2 priority class of
service (CoS) for the configured VLAN. The range is 0 to 7;
the default is 5.
• dscp dvalue — (Optional) Specifies the differentiated services
code point (DSCP) value for the configured VLAN. The range
is 0 to 63; the default is 46.
•
dot1p
— (Optional) Configures the telephone to use IEEE 802.1p
priority tagging and use VLAN 0 (the native VLAN).
•
none
—
(Optional) Do not instruct the IP telephone about the
voice VLAN. The telephone uses the configuration from the
telephone key pad.
• untagged — (Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
•
untagged
—
(Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
68
How to Configure LLDP, LLDP-MED, and Wired Location Service