Cisco Catalyst 2960 Series, Configuration Manual

Page: 267 / 2288

C H A P T E R
13
Configuring IPv6 Unicast Routing
• Finding Feature Information, page 185
• Information About Configuring IPv6 Host Functions , page 185
• Configuration Examples for IPv6 Unicast Routing, page 196
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to
http://www.cisco.com/go/cfn . An account on Cisco.com is not
required.
Information About Configuring IPv6 Host Functions
This chapter describes how to configure IPv6 host functions on the Catalyst 2960, 2960-S, and 2960-C.
To use IPv6 Host Functions, the switch must be running the LAN Base image.
Note
For information about configuring IPv6 Multicast Listener Discovery (MLD) snooping, see Configuring MLD
Snooping .
To enable dual stack environments (supporting both IPv4 and IPv6) on a Catalyst 2960 switch, you must
configure the switch to use the a dual IPv4 and IPv6 switch database management (SDM) template. See the
"Dual IPv4 and IPv6 Protocol Stacks" section . This template is not required on Catalyst 2960-S switches.
For complete syntax and usage information for the commands used in this chapter, see the Cisco IOS
documentation referenced in the procedures.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
185