Cisco Catalyst 2960 Series, Configuration Manual

Page: 596 / 2288

Table 53: Match Parameters
Purpose Command
Specifies a match to datalink or Layer 2 fields. The
following command options are available:
•
ethertype
—
Matches to the ethertype of the
packet.
•
mac
— Matches the source or destination MAC
address from packets at input.
When a datalink flow monitor is assigned to
an interface or VLAN, it only creates flows
for non-IPv6 or non-IPv4 traffic. Note
match datalink { ethertype | mac { destination
address input | source address input }}
Specifies a match to the IPv4 fields. The following
command options are available:
•
destination
— Matches to the IPv4 destination
address-based fields.
•
protocol
—
Matches to the IPv4 protocols.
• source — Matches to the IPv4 source address
based fields.
•
tos
—
Matches to the IPv4 Type of Service
fields.
match ipv4
{
destination
{
address
} |
protocol
|
source { address } | tos }
Specifies a match to the IPv6 fields. The following
command options are available:
•
destination
—
Matches to the IPv6 destination
address-based fields.
• flow-label — Matches to the IPv6 flow-label
fields.
•
protocol
— Matches to the IPv6 payload protocol
fields.
•
source
—
Matches to the IPv6 source address
based fields.
• traffic-class — Matches to the IPv6 traffic class.
match ipv6 { destination { address } | flow-label |
protocol | source { address } | traffic-class }
Specifies a match to the Transport Layer fields. The
following command options are available:
•
destination-port
— Matches to the transport
destination port.
•
source-port
—
Matches to the transport source
port.
match transport
{
destination-port
|
source-port
}
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
514
Information About NetFlow Lite