Cisco Catalyst 2960 Series, Configuration Manual

Page: 1394 / 2288

SUMMARY STEPS
1.
enable
2. configure terminal
3.
interface interface-id
4.
ip arp inspection limit {rate pps [burst interval seconds] | none}
5. exit
6.
Use the following commands:
• errdisable detect cause arp-inspection
• errdisable recovery cause arp-inspection
• errdisable recovery interval interval
7.
exit
8. Use the following show commands:
• show ip arp inspection interfaces
•
show errdisable recovery
9. show running-config
10.
copy running-config startup-config
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if prompted. enable
Step 1
Example:
Switch> enable
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the interface to be rate-limited, and enter interface
configuration mode. interface interface-id Step 3
Limits the rate of incoming ARP requests and responses on the
interface. The default rate is 15 pps on untrusted interfaces and
unlimited on trusted interfaces. The burst interval is 1 second.
ip arp inspection limit {rate pps [burst
interval seconds] | none}
Step 4
The keywords have these meanings:
• For
ratepps
, specify an upper limit for the number of incoming
packets processed per second. The range is 0 to 2048 pps.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1312
Limiting the Rate of Incoming ARP Packets