Cisco Catalyst 2960 Series, Configuration Manual

Page: 143 / 2288

If you change a location address on the switch, the switch sends an NMSP location notification message that
identifies the affected ports and the changed address information.
Default LLDP Configuration
Table 8: Default LLDP Configuration
Default Setting Feature
Disabled LLDP global state
120 seconds LLDP holdtime (before discarding)
30 seconds LLDP timer (packet update frequency)
2 seconds LLDP reinitialization delay
Disabled to send and receive all TLVs LLDP tlv-select
Disabled LLDP interface state
Disabled LLDP receive
Disabled LLDP transmit
Disabled to send all LLDP-MED TLVs. When LLDP is globally
enabled, LLDP-MED-TLV is also enabled. LLDP med-tlv-select
Restrictions for LLDP
• If the interface is configured as a tunnel port, LLDP is automatically disabled.
• If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If the switchport voice vlan vlan-id is already configured on an interface,
you can apply a network-policy profile on the interface. This way the interface has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
• You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
61
LLDP, LLDP-MED, and Wired Location Service Overview